New innovative fender speaker housings for your Honda Foreman 400/450! Custom sized speaker housings fit perfectly snug on your OEM fender plastics.  Sold as a complete speaker kit with all necessary components to install on the vehicle.  Or you can purchase the unloaded speaker housings and build your own speaker kit. (These speaker housings fit 6.5" speakers)

What's Included:

• Unloaded Option:
• (2) Speaker Housings/Pods
• Waterproof On/Off Switch with Red LED Light (pre-installed)
• Mounting Hardware
• You must select NO for the LED speaker lights with this option.

• Waterproof Complete "Bluetooth" Speaker Kit
• 240W Knight ATV KS23 6.5" Marine Speakers (Waterproof)
• 600W Marine amplifier (Bluetooth accessible or aux wire ready) fully waterproof and submergible! You can completely submerge this, deep, for a long time, and it will keep working!
• Mounting Hardware
• Waterproof On/Off Switch with Red LED Light
• All necessary wiring to make it plug and play
• 2-Year Warranty

Unique Features:

• Custom fit. Specifically designed for Honda ATV fender plastics.
• Full speaker kits comes with all necessary wiring to make it plug and play.
• LED option can always be added later. All speakers now come with the LED's. If you do not select the LED option and want it later you can purchase the controller, remote and wiring separately.

Fitment:

• Honda Foreman 400 (1995-2003)
• Honda Foreman 450 (1998-2004)

Installation:

1. Place the left speaker housing (the one with the amplifier mounted inside it) on the left fender so that it sits flush against the surface, slide it around until you feel it set into its perfect location.
2. Drill 4 holes into the fender for the mounting bolts, don't bolt it on yet.
3. After that, notice where the wires will be, about center but a little lower than the speaker. Drill a hole near the bottom center of the speaker housing for the wiring harnesses.
4. Push all the wires through and then mount the speaker housing to the fender. DO NOT over tighten the bolts to secure the housing to the fender plastic.
5. Run the wires for the other speaker, and LED (if purchased), to the right speaker. Somewhere along the front of the ATV, keep the wires away from moving and hot parts. Wait to secure these with cable ties until after the speakers are fully installed and tested.
6. Line up the right speaker housing on the right fender. Drill the same holes as the left side.
7. Push the wires from the left side through that center hole and connect the wires to the speaker and the LED (if purchased), make sure to line up the little arrows on the LED wires.
8. Bolt the speaker to the fender, DO NOT over tighten the bolts.
9. Run the Black and Red wire from the left speaker to your battery, connect the red wire to positive and black wire to negative.
10. Turn it on and connect Bluetooth and test LED's.
11. Fasten all the wiring away from moving and hot parts using cable ties. Use duct tape or silicone to fill in around the holes that the wires come out of.
12. Done! Go ride and enjoy!